SECTION 5-C 1956 BUICK DYNAFLOW REMOVAL AND INSTALLATION, DISASSEMBLY AND ASSEMBLY 5-13 REMOVAL AND INSTALLATION OF 1956 BUICK DYNAFLOW TRANSMISSION Removal of 1956 Buick Dynaflow Transmission Hoist front and rear of car and rest it solidly on stands placed under frame. Frame side rail should be at least 20" above floor. Disconnect torque tube from [...]
SECTION 5-C 1955 BUICK DYNAFLOW TRANSMISSION REMOVAL AND INSTALLATION, DISASSEMBLY AND ASSEMBLY 5-13 1955 BUICK DYNAFLOW REMOVAL AND INSTALLATION Removal of 1955 Buick Dynaflow Transmission Hoist front and rear of car and rest it solidly on stands placed under frame. Frame side rail should be at least 20" above floor. Disconnect torque tube from torque ball [...]
SECTION 5-A 1955 BUICK DYNAFLOW SPECIFICATIONS, DESCRIPTION AND OPERATION 5-1 1955 BUICK DYNAFLOW GENERAL SPECIFICATIONS 1955 Buick Dynaflow Transmission Identification Number A production identification number is stamped into the lower edge of the reaction shaft flange directly to rear of the high (left) accumulator. The identification number consists of a letter followed by a number. See [...]
SECTION 5-C 1954 BUICK DYNAFLOW TRANSMISSION REMOVAL AND INSTALLATION, DISASSEMBLY AND ASSEMBLY 5-13 1954 BUICK DYNAFLOW REMOVAL AND INSTALLATION 1954 Buick Dynaflow Removal Hoist front and rear of car and rest it solidly on stands placed under frame. Frame side rail should be at least 20" above floor. Disconnect torque tube from torque ball and [...]
SECTION 4-E 1952 BUICK DYNAFLOW REMOVAL AND INSTALLATION, DISASSEMBLY AND ASSEMBLY 4-27 1952 BUICK DYNAFLOW REMOVAL Raise right side of hood and remove bell housing dowel bolt located to rear of cranking motor solenoid, using a suitable offset brass drift. This bolt cannot be removed from under the car. Hoist front and rear of car [...]
SECTION 4-C 1952 BUICK DYNAFLOW SPECIFICATIONS, DESCRIPTION, AND OPERATION 4-15 1952 BUICK DYNAFLOW GENERAL SPECIFICATIONS 1952 Buick Dynaflow Transmission Identification Number A production identification number is stamped into the lower edge of the reaction shaft flange directly to rear of the high (left) accumulator. The identification number consists of a letter followed by a number. See [...]
SECTION 4-C 1951 BUICK DYNAFLOW SPECIFICATIONS, DESCRIPTION, AND OPERATION 4-15 1951 BUICK DYNAFLOW GENERAL SPECIFICATIONS 1951 Buick Dynaflow Transmission Identification Number A production identification number is stamped into the lower edge of the reaction shaft flange directly to rear of the high (left) accumulator. The identification number consists of a letter followed by a number. See [...]