1950 Buick Dynaflow Transmission (Automatic)
Controls for 1950 Buick Dynaflow Transmission Driving are as simple as you can imagine. A foot-brake, an accelerator & a control lever. Read more!
Controls for 1950 Buick Dynaflow Transmission Driving are as simple as you can imagine. A foot-brake, an accelerator & a control lever. Read more!
SECTION 13-F 1950 BUICK HYDRO-LECTRIC POWER SYSTEM 13-26 GENERAL DESCRIPTION OF 1950 BUICK HYDRO-LECTRIC POWER SYSTEM The 1950 Buick Hydro-Lectric Power System is standard on Models 56C, 76C and 76R, and is optional equipment on Models 52 and 72. This system provides power operation of the folding top, front seat, door and rear quarter windows. The [...]
SECTION 13-E 1950 BUICK CONVERTIBLE COUPE BODIES 13-23 OPERATION AND CARE OF FOLDING TOP The folding tops on 1950 Buick convertible coupes are operated by the Hydro-Lectric Power System described in Section 13-F. The following instructions should be observed by anyone operating the top to raise and lower it. Lowering the Top and Installing Boot STOP [...]
SECTION 13-D 1950 BUICK INTERIOR TRIM AND SEATS 13-18 1950 BUICK DOOR TRIM PAD REMOVAL AND INSTALLATION Remove all door inside handles by pushing inward on the escutcheon and removing the handle retaining spring, using Door Handle Pliers KMO 601. A slight rotating motion of the pliers will easily remove the retaining spring. See figure [...]
SECTION 13-C 1950 BUICK WINDSHIELD WIPERS - CLOSED BODY WINDSHIELD, WINDOW GLASSES AND VENTILATORS 13-10 1950 BUICK WINDSHIELD WIPERS Description of 1950 Buick Windshield Wiper The 1950 Buick windshield wiper motor is mounted on an auxiliary drive which is attached to the front face of the cowl panel. The motor shaft is coupled to a short shaft [...]
SECTION 13-B 1950 BUICK DOORS AND COMPARTMENT LIDS 13-5 1950 BUICK DOOR LOCKS AND HANDLES Description of 1950 Buick Door Locks and Handles Each door lock is operated by a push button in the stationary outside handle and also by an inside handle and remote control assembly which is connected to the lock by a link. [...]
GROUP 13 - 1950 BUICK BODY 13-1 1950 BUICK BODY INTRODUCTION Scope of Group 13 Group 13 contains the most essential adjustment and replacement procedures required for ordinary servicing of bodies. These procedures may be performed by any competent mechanic without specialized experience in 1950 Buick body repair work, and may be accomplished with tools and [...]
GROUP 12 1950 BUICK CHASSIS SHEET METAL 12-1 DESCRIPTION OF 1950 BUICK CHASSIS SHEET METAL Front End Sheet Metal Assembly The front end sheet metal assembly consists of front fenders and skirts, radiator grille frame, radiator mounting strap and radiator core, radiator pan, outside air intake ducts which are attached to the fender skirts, and [...]
SECTION 11-B 1950 BUICK RADIO 11-6 1950 BUICK RADIO DESCRIPTION AND OPERATING INSTRUCTIONS The Buick Sonomatic and Selectronic radio installations consist of a receiver set with built-in speaker mounted at the center of the instrument panel and a 4-section antenna mounted just above the center of windshield. The Selectronic radio installation also includes a foot [...]
GROUP 11 - 1950 BUICK ACCESSORIES MAINTENANCE 11-1 HEATER AND DEFROSTER Description of Heater and Defroster The heater and the defroster are separate units which may be operated together or independently as desired. The heater and defroster installation is an automatically controlled hot water system which uses forced air to insure positive distribution of heat. [...]