1950 Buick Special Series Wiring Diagrams
1950 Buick Wiring Diagram - Models 4407 and 4407B 1950 Buick Wiring Diagram - Model 4408
1950 Buick Wiring Diagram - Models 4407 and 4407B 1950 Buick Wiring Diagram - Model 4408
1950 BUICK REAR COMPARTMENT LID Cover lower roof panel below back window to protect finish and raise compartment lid. Disconnect and remove light wire from lid. Scribe position of hinge straps on lid. Remove two (2) retaining bolts from each hinge strap and remove lid. Use care to prevent damaging the body finish. To replace, [...]
1950 BUICK REAR QUARTER OUTSIDE MOLDINGS 1950 BUICK REAR QUARTER BELT MOLDING (4-DOOR DYNAMIC COUPE) Open rear door and remove single screw retaining end flange of molding to rear body pillar. Open rear compartment lid, and from inside rear compartment along inner side of quarter panel remove the belt molding retaining nuts, cup washers, and [...]
1950 BUICK HEADLINING 1950 BUICK HEADLINING REMOVAL Preparatory to removing the 1950 Buick headlining, the following parts must first be removed: (a) garnish molding around windshield, rear quarter, and back windows; (b) sunshades and brackets; (c) dome lamp assembly; (d) rear seat cushion ;:v1d rear seat back; (e) rear seat back compartment top trim panel [...]
FRONT SEAT AND SEAT ADJUSTER Note: The 1950 Buick front seat cushion cannot be lifted out. Remove the 1950 Buick front seat side panel, including extension. Remove the two (2) seat adjuster to floor pan bolts from each of four seat adjuster supports. 1950 Buick Front Seat Adjuster Remove the 1950 Buick front seat assembly [...]
1950 BUICK DOOR OUTSIDE HANDLE REMOVAL Release the 1950 Buick door rubber weatherstrip at the lock pillar face to expose flat spring handle retainer. Remove screw holding retainer to pillar face. Pull retainer out until handle can be removed. 1950 Buick Door Outside Handle Removal INSTALLATION Door lock bolt by pushing to "up" [...]
1950 BUICK INSTRUMENT PANEL COMPARTMENT DOOR Remove two screws "A" holding single curved door stop to inner face of door. See Figure No. 11. Remove three screws "B" holding hinge to inner face of door. To install, reverse this operation. ADJUSTMENT 1950 Buick Instrument Panel Compartment Door For in and out adjustment at [...]
1950 BUICK WINDSHIELD GLASS AND GLASS CHANNEL Protect the finish by masking around the 1950 Buick windshield opening and laying a suitable covering across the hood and front fender. Inside the car, remove the rear view mirror, inner division molding, including upper and lower escutcheons also the garnish molding. At bottom of windshield remove the defroster [...]
1950 BUICK BASIC METAL CONSTRUCTION including NAMES OF METAL PANEL ASSEMBLIES 1950 BUICK "40" SERIES BODY FISHER STYLES 4407-4408 1950 Buick 40-Series 4-door Coupe Chassis - Rear View 1950 Buick 40-Series 4-door Coupe Chassis - Front View 1950 Buick 40-Series 2-door Coupe Chassis - Rear View 1950 Buick [...]