SECTION 6-B - 1959 BUICK REAR AXLE SERVICE PROCEDURES 6-4 REMOVAL AND INSTALLATION OF 1959 BUICK REAR AXLE ASSEMBLY It is not necessary to remove the 1959 Buick rear axle assembly for repair or replacement of a strut rod, an axle shaft, a wheel bearing, or a wheel bearing seal ; however, the 1959 Buick [...]
SECTION 6-B 1958 BUICK REAR AXLE SERVICE PROCEDURES 6-4 REMOVAL AND INSTALLATION OF 1958 BUICK REAR AXLE ASSEMBLY It is not necessary to remove the 1958 Buick rear axle assembly for repair or replacement of a strut rod, an axle shaft, a wheel bearing, or a wheel bearing seal; however, the 1958 Buick rear axle [...]
SECTION 6-B 1957 BUICK REAR AXLE SERVICE PROCEDURES 6-4 REMOVAL AND INSTALLATION OF 1957 BUICK REAR AXLE ASSEMBLY It is not necessary to remove the 1957 Buick rear axle assembly for repair or replacement of a strut rod, an axle shaft, a wheel bearing, or a wheel bearing seal; however, the 1957 Buick rear axle [...]
SECTION 6-B 1956 BUICK REAR AXLE SERVICE PROCEDURES 6-4 REMOVAL AND INSTALLATION OF 1956 BUICK REAR AXLE ASSEMBLY It is not necessary to remove the 1956 Buick rear axle assembly for repair or replacement of a strut rod, an axle shaft, a wheel bearing, or a wheel bearing seal; however, the 1956 Buick rear axle [...]
1956 REAR AXLE CHANGE The following is a reprint of Special Service Letter - Dealer No. 179, dated May 22, 1956. Because of many rear axle differential case and related parts changes that were made up until the present time and changes that will go into effect within a month or so, we have prepared [...]
6-1 REAR AXLE SPECIFICATIONS Tightening Specifications Use a reliable torque wrench to tighten the parts listed, to insure proper tightening without straining or distorting parts. These specifications are for clean and lightly lubricated threads only; dry or dirty threads produce increased friction which prevents accurate measurement of tightness. 1956 Buick Rear Axle Specifications [...]