2014 2014/11

1958 Buick Frame and Sheet Metal

2017-06-10T21:52:40+00:00By |Categories: 1958, 1958 Buick Product School Manual, Literature|Tags: , , , , , , |0 Comments

12-1 1958 BUICK FRAME Buick's Air-Poise and Coil Spring Suspensions require the use of different frames in 1958. The frames are basically the same with the exception of the construction of the front and rear cross-members. See Figure 12-1. 1958 Buick Air-Poise and Coil Spring Rear Cross-Member NOTE: [...]

2014 2014/11

1950 Buick Frame and Bumpers

2017-03-01T19:25:26+00:00By |Categories: 1950, 1950 Buick Shop Manual, Literature|Tags: , , , , , , , , |0 Comments

GROUP 9 - 1950 BUICK FRAME AND BUMPERS 9-1 DESCRIPTION OF 1950 BUICK FRAME The 1950 Buick frame has high carbon pressed steel members riveted and welded together to form a rigid assembly. The outer and inner side rails, center diagonal cross members and rear cross members are of channel section. The front cross member [...]

2014 2014/10

1953 Buick Frame & Bumpers Maintenance

2017-03-01T19:25:37+00:00By |Categories: 1953, 1953, 1953 Buick Product Service Bulletins, Literature|Tags: , , , , , , |0 Comments

1953 Buick Frame SPRING & SHIM CAMPAIGN 1953 - 76X SKYLARK Special Service Letter - Dealer No. 124 A change in the front suspension has been made in production on all 70 Series cars to improve appearance and ride. This change is to be campaigned on all Skylark (76X) models prior to Serial [...]

2014 2014/10

1951 Buick Frame & Bumpers Maintenance

2017-03-01T19:25:44+00:00By |Categories: 1951, 1951, 1951 1952 Buick Product Service Bulletins, Literature|Tags: , , , , , , , , |0 Comments

BUMPER BOLT TORQUE In order to obtain satisfactory results with a bumper jack it is imperative that the bumper back bar to frame bolts be torqued to recommended figures. Loose bolts at these points will allow the bumpers to twist upward far enough to make rear wheel removal difficult or even impossible. Correct torque specifications [...]

2014 2014/02

1957 Buick Frame and Sheet Metal Maintenance

2017-03-01T19:26:03+00:00By |Categories: 1957, 1957 Buick Product School Manual, Literature|Tags: , , , , , , |0 Comments

12-1 FRAME Frames for 1957 have been entirely redesigned. Lowering of the overall car height has been accomplished through newly designed side rails and cross-members. The new design incorporates added strength where required for the new body. The front cross-member has been revised to accommodate the new ball-joint type of front suspension and new front [...]

2014 2014/02

1950 Buick Frame Maintenance

2015-08-30T20:43:34+00:00By |Categories: 1950, 1950, 1950 Buick Product Service Bulletins Abridged Edition, Literature|Tags: , , , , , |0 Comments

The service stock of Group 7.010, Part No.1393687, 1950 Buick Frame Front Cross Member for 1948-40-50 and 1949-40 jobs will be supplied with revised end flanges. This revision makes it necessary to weld the cross member to the side rails instead of using rivets as originally found in production 1950 Buick frames.

Go to Top