SECTION 2-G - 1959 BUICK ENGINE MOUNTING ADJUSTMENT, FLYWHEEL REPLACEMENT, ENGINE BALANCING 2-25 1959 BUICK ENGINE MOUNTING ADJUSTMENT The 1959 Buick engine and transmission when properly aligned with the frame will rest in a normal position which does not impose any shear strain on the rubber mounting pads. During assembly, the transmission support is accurately [...]
SECTION 2-G 1958 BUICK ENGINE MOUNTING ADJUSTMENT, FLYWHEEL REPLACEMENT, ENGINE BALANCING 2-25 1958 BUICK ENGINE MOUNTING ADJUSTMENT The engine and transmission when properly aligned with the frame of the car, must rest in a normal position which does not impose any shear strain on any of the rubber mounting pads. The following procedure should be [...]
SECTION 2-G 1957 BUICK ENGINE MOUNTING ADJUSTMENT, FLYWHEEL REPLACEMENT, ENGINE BALANCING 2-25 1957 BUICK ENGINE MOUNTING ADJUSTMENT The 1957 Buick engine and transmission assembly must rest in a .normal position which does not impose any side strain on the three rubber mounting pads. The following procedure may be used to obtain proper adjustment of the [...]
SECTION 2-B 1957 BUICK ENGINE DESCRIPTION 1957 Buick Engine, End Sectional View 2-4 1957 BUICK ENGINES AND MOUNTINGS 1957 Buick Engines in Each Series The 1957 Buick Fireball V-8 engines used in all series are of the same basic design, differing only in compression ratio, power, carburetor equipment and intake and exhaust manifolds. [...]
SECTION 2-G 1954 BUICK ENGINE MOUNTING ADJUSTMENT, FLYWHEEL REPLACEMENT, ENGINE BALANCING 2-25 1954 BUICK ENGINE MOUNTING ADJUSTMENT The engine and transmission assembly must rest in a normal position which does not impose any side strain on the three 1954 Buick rubber mounting pads. The following procedure may be used to obtain proper adjustment of the [...]
SECTION 2-G SERVICE ON 1952 BUICK ENGINE MOUNTINGS, FLYWHEEL AND HOUSING 2-31 1952 BUICK ENGINE MOUNTING ADJUSTMENT The following procedure must be used to center the engine in the frame and adjust the engine and transmission mountings. Disconnect torque tube from torque ball. Tighten 1952 Buick engine mounting brackets to the crankcase and frame front X [...]