2014 2014/11

1956 Buick Clutch, S-M-Transmission and Universal Joint

2017-03-01T19:25:02+00:00By |Categories: 1956, 1956 Product School Manual, Literature|Tags: , , , , , , , , , , |0 Comments

4-1 CLUTCH A new single plate, dry disc clutch is used in cars equipped with synchromesh transmissions. The clutch is of the conventional design with coil type clutch springs and three release levers. The clutch cover is bolted to the flywheel and three lugs on the pressure plate engage slots in the cover to transmit [...]

2014 2014/11

1950 Buick Synchromesh Transmission and Universal Joint

2017-03-01T19:25:29+00:00By |Categories: 1950, 1950 Buick Shop Manual, Literature|Tags: , , , , , , , , , , , , , |0 Comments

SECTION 4-B 1950 BUICK SYNCHROMESH TRANSMISSION AND UNIVERSAL JOINT 4-7 1950 BUICK SYNCHROMESH TRANSMISSION AND UNIVERSAL JOINT SPECFICATIONS 1950 Buick Synchromesh Transmission Tightening Specifications 1950 Buick Synchromesh Transmission Tightening Specifications 1950 Buick Synchromesh Transmission Specifications 1950 Buick Synchromesh Transmission Specifications 1950 Buick Synchromesh Transmission Specification NOTE: Where dimensions and limits [...]

2014 2014/10

1953 Buick Clutch & Transmission Maintenance

2017-03-01T19:25:38+00:00By |Categories: 1953, 1953, 1953 Buick Product Service Bulletins, Literature|Tags: , , , , , , , , |1 Comment

DYNAFLOW CAMPAIGN On Flint built Dynaflow cars with approximate starting serial no. 16833391 and ending with serial no. 16838670, there is the possibility that a pressure regulator valve was installed in the Dynaflow which did not have a bleed hole through the narrow end land. This can, in the case of cold oil, cause rather [...]

2014 2014/10

1952 Buick Clutch & Transmission Maintenance

2017-03-01T19:25:41+00:00By |Categories: 1951 1952 Buick Product Service Bulletins, 1952, Literature|Tags: , , , , , , , , |0 Comments

DYNAFLOW OIL COOLER 1951 ALL SERIES Special Service Letter - Dealer No. 103 - December 14, 1951 SUBJECT: Dynaflow Oil Coolers During January, February and March and part of April a critical material situation forced us to use some Dynaflow oil coolers fabricated from material other than Cupro-Nickle or copper. Some internal and external cooler [...]

2014 2014/10

1951 Buick Clutch & Transmission Maintenance

2017-03-01T19:25:45+00:00By |Categories: 1951, 1951, 1951 1952 Buick Product Service Bulletins, Literature|Tags: , , , , , , , , |1 Comment

DYNAFLOW OIL CHANGE 1948 THRU 1951 DYNAFLOW Supplements Sec. 1-A, Par. 1-4, 1951 SM and Sec. 5, Par. 20{b), 1948-49-50 Dynaflow SM. At the 25,000 mile Dynaflow oil change, the oil pan and screen should be removed from the transmission and thoroughly cleaned before the transmission is refilled with new oil.   DYNAFLOW PUMP COVER [...]

2014 2014/10

1954 Buick Transmissions Maintenance

2017-03-01T19:25:48+00:00By |Categories: 1954, 1954, 1954 Buick Product Service Bulletins Abridged Edition, Literature|Tags: , , , , , , , |0 Comments

1954 LOW BAND AND CLUTCH REPRINT OF SPECIAL LETTER, NO. 142 In the second paragraph we stated that Engineering would release a special shift control valve with wider lands which will enable the use of the "4A" valve bodies by replacing this valve only, on the valve bodies that are marked by a date (9 [...]

2014 2014/02

1957 Buick Clutch, Synchromesh Transmission and U-Joint Maintenance

2017-03-01T19:26:05+00:00By |Categories: 1957, 1957 Buick Product School Manual, Literature|Tags: , , , , , , , , , |0 Comments

4-1 CLUTCH ASSEMBLY A new type centrifugal weighted clutch pres­ sure plate is used in 1957. The outer ends of the release Ievers are weighted so that at higher engine speeds where slipping is liable to occur, centrifugal force causes more pressure to be applied on the pressure plate. The faster the clutch revolves, the [...]

Go to Top