SECTION 1-B 1956 BUICK BEARING SERVICE (BALL AND ROLLER) The instructions in this Section cover removal, installation, cleaning and inspection of all ball and roller bearings used in the various units of the vehicle. These instructions must be carefully followed to avoid failure of bearings after any repair work in which they are involved. [...]
SECTION 6-B 1955 BUICK REAR AXLE SERVICE PROCEDURES 6-4 REMOVAL AND INSTALLATION OF 1955 BUICK REAR AXLE ASSEMBLY It is not necessary to remove the 1955 Buick rear axle assembly for any of the repairs outlined in this section; however, these procedures can be used as outlined if the assembly is removed from the car. The [...]
SECTION 1-B 1955 BUICK BEARING SERVICE (BALL AND ROLLER) The instructions in this Section cover removal, installation, cleaning and inspection of all ball and roller bearings used in the various units of the vehicle. These instructions must be carefully followed to avoid failure of bearings after any repair work in which they are involved. [...]
SECTION 2-E 1954 BUICK REPLACEMENT OF CRANKSHAFT AND CONNECTING ROD BEARINGS, PISTONS AND RINGS 2-17 REPLACEMENT OF 1954 BUICK CONNECTING ROD BEARINGS A connecting rod bearing consists of two halves or shells which are alike and interchangeable in rod and cap. When the shells are placed in rod and cap the ends extend slightly beyond [...]
SECTION 2-E - 1953 BUICK REPLACEMENT OF ENGINE PARTS - CRANKSHAFT AND CONNECTING ROD BEARINGS, PISTONS AND RINGS 2-17 REPLACEMENT OF 1953 BUICK V-8 CONNECTING ROD BEARINGS A connecting rod bearing consists of two halves or shells which are alike and interchangeable in rod and cap. When the shells are placed in rod and cap [...]
SECTION 1-B 1952 BUICK BEARING SERVICE (BALL AND ROLLER) The instructions in this Section cover removal, installation, cleaning and inspection of all ball and roller bearings used in the various units of the vehicle. These instructions must be carefully followed to avoid failure of 1952 Buick bearings after any repair work in which they are involved. [...]
7-1 1951 BUICK STEERING GEAR AND TIE ROD SPECIFICATIONS Tightening Specifications Use a reliable torque wrench to tighten the parts listed to insure proper tightness without straining or distorting parts. These specifications are for clean and lightly lubricated threads only; dry or dirty threads produce increased friction which prevents accurate measurement of tightness. 1951 [...]
SECTION 5-C 1951 BUICK REAR AXLE REMOVAL AND DISASSEMBLY PROCEDURES 5-7 1951 BUICK REAR AXLE ASSEMBLY REMOVAL AND INSTALLATION When to Remove Rear Axle Assembly The 1951 Buick rear axle assembly should be removed from the car before overhaul if there is external indication of damage to rear axle or third member housings or strut rods, or [...]
SECTION 2-E REPLACEMENT OF 1951 BUICK CRANKSHAFT AND CONNECTING ROD BEARINGS, PISTONS AND RINGS 2-21 REPLACEMENT OF CONNECTING ROD BEARINGS A connecting rod bearing consists of two halves or shells which are alike and interchangeable in rod and cap. When the shells are placed in rod and cap the ends extend slightly beyond the parting [...]
SECTION 1-B 1951 BUICK BEARING SERVICE (BALL AND ROLLER) The instructions in this Section cover removal, installation, cleaning and inspection of all ball and roller bearings used in the various units of the vehicle. These instructions must be carefully followed to avoid failure of 1951 Buick bearings after any repair work in which they are involved. [...]