2014 2014/11

1952 Buick Chassis Suspension Trouble Diagnosis

2017-03-01T19:24:06+00:00By |Categories: 1952, 1952 Buick Shop Manual, Literature|Tags: , , , , , , , , , , , , , |0 Comments

SECTION 6-B 1952 BUICK CHASSIS SUSPENSION TROUBLE DIAGNOSIS 6-9 ABNORMAL TIRE WEAR General Operating Conditions Assuming that there is no misalignment condition to cause unnatural wear, the life of tires depends largely upon car operating conditions and driving habits. Tires wear at a much faster rate in some localities than in others because of road and [...]

2014 2014/11

1952 Buick Chassis Suspension Specifications

2017-03-01T19:24:07+00:00By |Categories: 1952, 1952 Buick Shop Manual, Literature|Tags: , , , , , , , , , , , , , , , , |0 Comments

SECTION 6-A 1952 BUICK CHASSIS SUSPENSION SPECIFICATIONS, DESCRIPTION, SERVICE RECOMMENDATIONS 6-1 1952 BUICK CHASSIS SUSPENSION SPECIFICATIONS Tightening Specifications Use a reliable torque wrench to tighten the parts listed, to insure proper tightness without straining or distorting parts. These specifications are for clean and lightly lubricated threads only; dry or dirty threads produce increased friction which prevents accurate [...]

2014 2014/11

1952 Buick Rear Axle Removal and Disassembly

2017-03-01T19:24:07+00:00By |Categories: 1952, 1952 Buick Shop Manual, Literature|Tags: , , , , , , , , , , , , , , , , |0 Comments

SECTION 5-C 1952 BUICK REAR AXLE REMOVAL AND DISASSEMBLY PROCEDURES 5-7 REMOVAL AND INSTALLATION OF 1952 BUICK REAR AXLE ASSEMBLY When to Remove - 1952 Buick Rear Axle Assembly The 1952 Buick rear axle assembly should be removed from the car before overhaul if there is external indication of damage to rear axle or third member housings [...]

2014 2014/11

1952 Buick Rear Axle Trouble Diagnosis

2017-03-01T19:24:07+00:00By |Categories: 1952, 1952 Buick Shop Manual, Literature|Tags: , , , , , , , , , |0 Comments

SECTION 5-B 1952 BUICK REAR AXLE TROUBLE DIAGNOSIS 5-3 ELIMINATION OF EXTERNAL NOISES When a 1952 Buick rear axle is suspected of being noisy it is advisable to make a thorough test to determine whether the noise originates in the tires, road surface, front wheel bearings, engine, transmission, or rear axle assembly. Noise which originates in [...]

2014 2014/11

1952 Buick Rear Axle Specifications

2017-03-01T19:24:08+00:00By |Categories: 1952, 1952 Buick Shop Manual, Literature|Tags: , , , , , , , |0 Comments

SECTION 5-A 1952 BUICK REAR AXLE SPECIFICATIONS AND DESCRIPTION 5-1 1952 BUICK REAR AXLE SPECIFICATIONS Tightening Specifications Use a reliable torque wrench to tighten the parts listed, to insure proper tightness without straining or distorting parts. The 1952 Buick Rear Axle specifications are for clean and lightly lubricated threads only; dry or dirty threads produce [...]

2014 2014/11

1952 Buick Dynaflow Removal and Installation

2017-03-01T19:24:08+00:00By |Categories: 1952, 1952 Buick Shop Manual, Literature|Tags: , , , , , , , , , , , , , , , , , , , , , , , , , , , , , , |0 Comments

SECTION 4-E 1952 BUICK DYNAFLOW REMOVAL AND INSTALLATION, DISASSEMBLY AND ASSEMBLY 4-27 1952 BUICK DYNAFLOW REMOVAL Raise right side of hood and remove bell housing dowel bolt located to rear of cranking motor solenoid, using a suitable offset brass drift. This bolt cannot be removed from under the car. Hoist front and rear of car [...]

2014 2014/11

1952 Buick Dynaflow Trouble Diagnosis

2017-03-01T19:24:08+00:00By |Categories: 1952, 1952 Buick Shop Manual, Literature|Tags: , , , , , , , , , , , |0 Comments

SECTION 4-D 1952 BUICK DYNAFLOW TROUBLE DIAGNOSIS-ADJUSTMENTS ON CAR 4-23 1952 BUICK DYNAFLOW TEST AND INSPECTION Road Test When improper operation of a 1952 Buick Dynaflow transmission is reported, time and expense will usually be saved by first making a thorough road test to observe operation in all ranges under appropriate driving conditions. The road test [...]

2014 2014/11

1952 Buick Dynaflow Transmission

2017-03-01T19:24:09+00:00By |Categories: 1952, 1952 Buick Shop Manual, Literature|Tags: , , , , , , , , , , , , , , , , , , , , |0 Comments

SECTION 4-C 1952 BUICK DYNAFLOW SPECIFICATIONS, DESCRIPTION, AND OPERATION 4-15 1952 BUICK DYNAFLOW GENERAL SPECIFICATIONS 1952 Buick Dynaflow Transmission Identification Number A production identification number is stamped into the lower edge of the reaction shaft flange directly to rear of the high (left) accumulator. The identification number consists of a letter followed by a number. See [...]

2014 2014/11

1952 Buick Synchromesh Transmission and Universal Joint

2017-03-01T19:24:09+00:00By |Categories: 1952, 1952 Buick Shop Manual, Literature|Tags: , , , , , , , , , , , , , |0 Comments

SECTION 4-B 1952 BUICK SYNCHROMESH TRANSMISSION AND UNIVERSAL JOINT 4-7 1952 BUICK S-M TRANSMISSION AND UNIVERSAL JOINT SPECIFICATIONS 1952 Buick Synchromesh Transmission Tightening Specifications 1952 Buick Synchromesh Transmission Tightening Specifications 1952 Buick Synchromesh Transmission Specifications 1952 Buick Synchromesh Transmission Specifications 1952 Buick Synchromesh Transmission Specification NOTE: Where dimensions and [...]

2014 2014/11

1952 Buick Clutch – Special and Super Series

2017-03-01T19:24:09+00:00By |Categories: 1952, 1952 Buick Shop Manual, Literature|Tags: , , , , , , , , |0 Comments

SECTION 4-A 1952 BUICK CLUTCH-SERIES 40-50 4-1 1952 BUICK CLUTCH SPECIFICATIONS Tightening Specifications 1952 Buick Clutch Tightening Specifications 1952 Buick Clutch Specifications 1952 Buick Clutch Specifications 1952 Buick Clutch Specification   4-2 DESCRIPTION OF 1952 BUICK CLUTCH 1952 Buick Clutch Assembly The single plate, dry disc clutch used in Series 40-50 [...]

Go to Top